FAQ - we believe the introduction of three-dimensional measuring devices. What is the difference between on-machine measurement.

	Copying a three-dimensional processing curved surface at the point file fin loaders, we would like to express the figure three-dimensionally. I want to measure automatically if possible. Stylus deviates coordinates of the surface in contact with the center when the stylus ball striking the curved surface, or not than not be measured correctly.
	I would like to measure the three-dimensional curved surface three-dimensionally with a point finder. I would like to measure automatically if possible. When the stylus ball strikes a curved surface, the coordinates of the surface in contact with the center are different and can not be correctly measured.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]　　[Tool Setter Series] [Centering Gauge Swing Type]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-machine measurement