FAQ - because electricity flows we use the current formula but you may not be firing from time to time. why?

	I measure casting. Iron, aluminum, brass etc. Why, I am using external contact type, but sometimes it does not light up.
	Cast iron, aluminum, brass, etc. originally flowed electricity, but when the surface temperature is high when taking out from the sand mold, the outer surface reacts with oxygen and turns into oxide.
	In the case of castings, when taking out from the mold well cool it out, or put it in water immediately, cool it then put into processing, if you can use energizing formula, if you can not, please use the internal contact type. If hot heat is transmitted to the inside, the electronic board will be damaged. The heat resistant temperature of the electronic parts mounted on the board is -50 to 70 ° C. If it exceeds this, it will be broken.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-machine measurement