Non-magneticPointCenteringToolCenteringOther

View the DVD for residual magnetism

Inquiries and document request from here

We have put together a frequently asked questions from users of everyone

よくある質問　製品について

このカテゴリの質問一覧を見る
質問 Although it is described as W4 or W6 in the centering gauge, what is it about?
答え The probe is φ10 as standard, but in case of W4 it is machined in two stages of φ10 and φ4.
In case of W6, the position of φ4 is φ6.
Both the concentricity with the shank is within 3/1000 mm.
Measurement of narrow grooves is possible.


W4
製品リンク Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking.
[Centering Gauge Swing Type]
このカテゴリの質問一覧を見る