FAQ - copying a three-dimensional processing curved surface at the point file fin loaders, we would like to express the figure three-dimensionally.

	I would like to follow three-dimensionally machined curved surfaces with a point finder and show the figure in three dimensions. I would like to measure automatically if possible. The coordinates when the stylus hits the curved surface and the coordinates of the center of the stylus sphere deviate and may not be measured correctly.
	The point finder is not a scanner. Copying measurement can not be performed with a normal probe.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-flight measurement