FAQ - we believe attempt to install a point finder to holder

	I plan to attach the point finder (PTN - 10) to the holder with the nut diameter φ 35, but if the outer diameter is Ø 35 or more, I will think about another method because the wrench does not pass.
	The outside diameter is φ33, but please do by hand tightening. If you tighten with a wrench, the shank warps and the accuracy gets worse.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-flight measurement