FAQ - self-made, but I want to control the machine, do you take the signal from the point finder?

	I would like to control my own machine, but can I get a signal from the point finder?
	It will be custom made, but you can take the signal from the cable. If you prepare a 1A power supply of 5 V voltage from the outside, you can　the trigger signal to the outside. The lag amount is constant and the error is 1 μ / Sec. The accuracy of the machine itself comes out. Interface is unnecessary. With normal skip, it is possible to measure with accuracy of 0.8 μm in F50 and with F100 with error of 0.16 μm if using fast skipping.
	Since I can not write here, please ask us for more information from "Inquiries" on our top page.
	Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking. [Point Finder Series]

A professional manufacturer of three-dimensional measuring devices for the on-machine measurement and in-flight measurement