お問い合わせや資料請求はこちらから

よくある質問 製品について

質問 What is the "centering"?
答え You must tell the position of the workpiece when machining the workpiece in the machine tools, there is no eye for the machine.
In the case of mold base to be used for mold, Y plane X and surface finish has been to clean the surface roughness at right angles.
Use this surface, I will tell you this position in the machine.
You need to tell the center in the case of a circle or hole. I call this centering.
Please see how the measurement of the centering gauge swing type and point finder for details.
製品リンク Products that are relevant to this question is as follows. It will jump to the corresponding page by clicking.
[Point Finder Series]  [Centering Gauge Swing Type]